Electronic Circuit Design

This subject has the following teaching availabilities in 2015:

200 hours

The prerequisites for this subject are:

Anti-requisite for this subject is:

For the purposes of considering request for Reasonable Adjustments under the Disability Standards for Education (Cwth 2005), and Student Support and Engagement Policy, academic requirements for this subject are articulated in the Subject Overview, Learning Outcomes, Assessment and Generic Skills sections of this entry.

It is University policy to take all reasonable steps to minimise the impact of disability upon academic study, and reasonable adjustments will be made to enhance a student's participation in the University's programs. Students who feel their disability may impact on meeting the requirements of this subject are encouraged to discuss this matter with a Faculty Student Adviser and Student Equity and Disability Support: http://services.unimelb.edu.au/disability

AIMS

This subject provides an in-depth coverage of transistor (MOSFET and BJT) devices and their use in common circuits. In particular, students will study topics including: transistor operating modes and switching; principles of CMOS circuits; transistor biasing; current-source/emitter-amplifiers; low-frequency response; followers; class B amplifiers; current limiting; current sources and mirrors; differential pairs; feedback in amplifiers and stability; operational amplifiers; operational amplifier circuits; and voltage regulation. This material will be complemented by exposure to circuit simulation software tools and the opportunity to further develop circuit construction/test skills in the laboratory.

INDICATIVE CONTENT

Design-focused field-effect and bipolar elementary transistor models, and design of elementary amplifier stages and biasing circuits. Static and dynamic behaviour of amplifier circuits including frequency response, feedback and stability, slew-rate and clipping. Operational amplifiers and opamp based circuits; voltage regulators, references and voltage converters. Verification of electronic circuits using simulation.

INTENDED LEARNING OUTCOMES (ILO)

On completing this subject the student should be able to:

1. Model and quantitatively analyse circuits with transistors and other nonlinear devices
2. Design and test amplifier circuits
3. Construct and test electronic circuits in the laboratory
4. Use software tools to simulate the behaviour of electronic circuits

• One written examination, not exceeding three hours at the end of semester, worth 70%
• Continuous assessment of submitted group project work( 2- 3 students), not exceeding 30 pages over the semester (approximately 25-30 hours of work per student), worth 20%
• A one-hour mid-semester test, worth 10%.

Hurdle requirement: Students must pass the written exam to pass the subject.

Intended Learning Outcomes (ILOs) 1, 2 and 4 are assessed in the final written examination, the mid-semester test, and continuous assessment of submitted project work. ILOs 3 and 4 are assessed as part of submitted laboratory exercise, and project work.

TBA

B. Razavi, Fundamental of Microelectronics, John Wiley & Sons, January 2008

This subject is not available as a breadth subject.

• Ability to apply knowledge of basic science and engineering fundamentals
• In-depth technical competence in at least one engineering discipline
• Ability to undertake problem identification, formulation and solution
• Ability to utilise a systems approach to design and operational performance
• Capacity for independent critical thought, rational inquiry and self-directed learning
• Ability to communicate effectively, with the engineering team and with the community at large

Credit may not be obtained for both ELEN30007(431-331) Electronic Circuit Design 2 and ELEN90056 Electronic Circuit Design

LEARNING AND TEACHING METHODS

In class lectures will alternate subject exposition by the reader with interactive discussion and problem solving. Laboratory experience will focus on solving meaningful design problems through circuit design and implementation, and verifying completed designs using real-world testing and simulation infrastructure.

INDICATIVE KEY LEARNING RESOURCES

Lecture and lab notes developed by instructors, textbook. Some material (lecture notes from other institutions etc.) publicly available through online resources.

CAREERS / INDUSTRY LINKS

Subject will also incorporate guest lectures from industry to provide an industry context to the topics covered.